Hematology: Thrombelastogram (TEG)
Testing
Basics
- Measures the Viscoelastic Properties of Clot Formation in Real Time
- Procedure:- A Small Cup of Blood is Activated & Rotates Around a Pin
- A Clot Forms Around the Pin & Parameters are Measured
 
- *Does Not Reliably Detect Effects of Commonly Use Anticoagulants
- Increasingly Being Used in Trauma- Conventional Tests Take a Long Time (Over 80 Minutes) and are Often Inaccurate by The Time They Result Due to Transfusions & Physiologic Changes
- Used to Guide Massive Transfusion & Identify Trauma Induced Coagulopathy
- May Decrease Transfusion Requirements (Controversial Area of Active Study)
- *See Trauma: Hemorrhagic Shock & Trauma Resuscitation
 
Commercial Types
- Thrombelastogram (TEG)- *Not “Thromboelastogram” – Common Misspelling
 
- Rotational Thromboelastography (ROTEM)- Similar but Different Nomenclature of Results
 
Modifications
- Speed – Based on Activating Agents:- Standard TEG – Uses Kaolin (A Type of Clay) to Activate Clot
- RapidTEG – Uses Kaolin & Tissue Factor to Accelerate Reaction
 
- Heparinase- Added Heparinase (Enzyme to Neutralize Heparin)
- Measures Inhibitory Effects of Heparin
 
- Functional Fibrinogen- Added Cytochalasin D (Alkaloid Produced by Fungus, Inhibits Platelet Activity)
- New Maximum Amplitude Differentiates Deficiencies in Fibrinogen vs Platelets
 
- Platelet Mapping- Added Adenosine Diphosphate (ADP) & Arachidonic Acid
- Measures Inhibitory Effects of Antiplatelet Agents (Aspiring/Clopidogrel)
 
Result Interpretation
Reaction Time (R Time)/Activated Clotting Time (ACT)
- Measures: Time to Initiate Clot Formation
- Normal:- R Time (Normal TEG): 5-10 Minutes
- ACT (RapidTEG): 80-140 Seconds
 
- Prolonged: Issue with Coagulation Factors- Treatment: FFP
 
K Time
- Measures: Time to Reach a Fixed Strength
- Normal: 1-3 Minutes
- Prolonged: Issue with Fibrinogen- Treatment: Cryoprecipitate
 
α Angle
- Measures: Speed of Growth
- Normal: 53-72 Degrees
- Low: Issue with Fibrinogen- Treatment: Cryoprecipitate
 
Maximum Amplitude (MA)
- Measures: Highest Vertical Amplitude
- Normal: 50-70 mm
- Low: Primarily an Issue with Platelets, Fibrinogen May Contribute- Treatment: DDAVP/Platelets & May Consider Cryoprecipitate
 
Lysis at 30 Minutes (LY30)
- Measures: Percentage of Clot Amplitude Reduction 30 Minutes After the Maximum
- Normal: 0-3%
- High: Excess Fibrinolysis- Treatment: TXA